- 01Getting Started
- 02Understanding the Operating Modes of Network Devices
- 03Entering Privileged EXEC Mode with enable
- 04Entering Configuration Mode with configure terminal
- 05Renaming the Switch with hostname
- 06Moving Between Modes with exit and end
- 07Entering Port Configuration with interface
- 08Enabling a Port with no shutdown
- 09Assigning an IP Address with ip address
- 10Labeling a Port with description
- 11Viewing the Configuration with show running-config
- 12Listing Interfaces with show ip interface brief
- 13What Is a VLAN? Splitting a Network Logically
- 14Creating a VLAN with vlan
- 15Naming a VLAN with name
- 16Setting the Port Type with switchport mode
- 17Assigning a Port to a VLAN with switchport access vlan
- 18Listing VLANs with show vlan brief
- 19Adding a Static Route with ip route
- 20Viewing the Routing Table with show ip route
- 21Testing Reachability with ping
- 22Tracing the Path with traceroute
- 23Checking OS Information with show version
- 24Checking the Time with show clock
- 25Saving the Configuration with copy running-config startup-config
- 26Saving with write memory (the Short Form)
- 27Setting a Login Message with banner motd
- 28Configuring the Console Line with line console 0
- 29Setting a Password with password
- 30Requiring the Password at Login with login
- 31Configuring Remote Access with line vty 0 4
- 32Creating an Access List with access-list
- 33Checking Access Lists with show access-lists
- 34Viewing the MAC Address Table with show mac address-table
- 35Discovering Neighbors with show cdp neighbors
- 36Viewing the ARP Table with show arp
- 37Understanding Loop Prevention with spanning-tree mode
- 38Rebooting the Device with reload
- 39Hands-On: Configure a Small Office Network
Configuring Remote Access with line vty 0 4
When you want to log into the device remotely over the network, use line vty 0 4. It enters the configuration mode for remote (virtual terminal) connections such as Telnet and SSH.
The syntax is line vty first-number last-number. 0 4 means sessions 0 through 4 — five simultaneous remote connections.
Running line vty 0 4 changes the prompt to (config-line)#, where you can configure the remote-login password and the login requirement.
A common stumble is confusing it with line console 0 and running the device with no remote-login password configured at all.
In real work, this is the essential setting that lets you operate devices from afar without traveling to them, combined with SSH for secure remote management.
🧑💻 You can type this command into the Networking pseudo terminal to try it yourself (this page itself has no interactive terminal).